Connection To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.4

Connection to C Controller module (MELSEC iQ-R Series)

This section describes the settings of the GOT and C Controller module (MELSEC iQ-R Series) in the following case of
system configuration.
Use CW Configurator for the C Controller module (MELSEC iQ-R Series) communication settings.
■1. System configuration
*1 These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
■2. [Module parameter] of CW Configurator
(1) Module parameter
Item
CH1
IP Address
Subnet Mask
Default Gateway
CH2
POINT POINT POINT
C Controller module (MELSEC iQ-R Series)
For details of C Controller module (MELSEC iQ-R Series), refer to the following manual.
➠
Manuals of C Controller module (MELSEC iQ-R Series)
<C Controller module (MELSEC iQ-R Series) >
2
(Use the default value for settings
other than the following.)
Network No.
PLC No.
IP address
Port No.
Communication format :UDP (fixed)
(3) [Controller Setting] and [Ethernet] of GT Designer3
*1
<GOT>
(Use the default value for settings
other than the following.)
Network No. :1
PLC No. :1
IP address :192.168.3.18
Port No. :5001
Communication format :UDP (fixed)
<C Controller module
1
(MELSEC iQ-R Series) >
(Use the default value for settings
other than the following.)
*1
Network No. :1 (virtual)
PLC No. :2 (virtual)
*1
IP address :192.168.3.3
Port No. :5006 (fixed)
Communication format :UDP (fixed)
:1 (virtual) *1
:3 (virtual)
*1
:192.168.3.4
:5006 (fixed)
Set value
Use
192.168.3.3
-
-
Not Use
5.4 PLC Side Setting
Setting necessity at GOT connection
5 - 45
5