Mitsubishi Electric GOT2000 Series Connection Manual page 669

(b) Link refresh setting
Item
Remote input (RX) refresh device
Remote output (RY) refresh device
Remote register (RWr) refresh device
(c) CC-Link configuration setting
• CC-Link configuration setting of station No.1 (GOT)
Item
Station type
*2
Exclusive station count
Reserve/invalid station select
Intelligent buffer select (word)
• CC-Link configuration setting of station No.2 (GOT)
Item
Station type
*2
Expanded cyclic setting
*2
Exclusive station count
Reserve/invalid station select
Intelligent buffer select (word)
*1 When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
*1
Ver.1 intelligent device station (fixed)
*1
Ver.2 intelligent device station (fixed)
Set value
Set as necessary.
: Necessary : As necessary
Set value
Exclusive station 1
No setting
(Use default value)
: Necessary : As necessary
Set value
Single
Exclusive station 1
No setting
(Use default value)
: Necessary : As necessary
12.4 PLC Side Setting
Setting necessity at GOT
connection
: Not necessary
Setting necessity at GOT
connection
: Not necessary
12
Setting necessity at GOT
connection
: Not necessary
12 - 27