Mitsubishi Electric GOT2000 Series Connection Manual page 594

■3. Parameter settings (Connecting to MELSEC iQ-R series) of System configuration1
(Network Type: CC IE Control)
(1) [Module parameter] of GX Works3
(a) Module parameter
Station type
*1
Network No.
Station number setting
Network range assignment
*1
(b) Network range assignment
LB/LW setting
*1
(1)
LB/LW setting (2)
LX/LY setting (1)
LX/LY setting (2)
Reserved station
Pairing
*1
10 - 16
10.4 PLC Side Setting
Item
Specify the same network No. as that of the GOT.
Item
Station No.1
LB
Station No.2
Station No.1
LW
Station No.2
*1
*1
*1
Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
Set value
Control station (fixed)
1
1
Refer to (b)
: Necessary
Set value
Start 0000H
End 00FFH
Start 0100H
End 01FFH
Start 00000H
End 000FFH
Start 00100H
End 001FFH
No setting
No setting
No setting
(Use default value)
: Necessary
Setting necessity at GOT connection
: As necessary : Not necessary
Setting necessity at GOT connection
: As necessary : Not necessary