Mitsubishi Electric GOT2000 Series Connection Manual page 337

(2) Q24DHCCPU-V/VG/LS
Use SW4PVC-CCPU-E for the C Controller (Q Series) setting utility.
(a) Connection settings
*1
IP Address
Subnet Mask
Default Gateway
*1 If the IP address of the C Controller module (Q Series) has been changed, input the changed IP address.
■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
Item
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠ 5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting C Controller module (Q Series) to a GOT, the setting items for the network
No. and station No. do not exist at the PLC side. However, these virtual values must be set
on the GOT side. Therefore, set the network No. and station No.
Set the network No. that is not existed on the network system and any station No..
Item
Set value
192.168.3.39
(Default)
255.255.255.0
(Default)
-
: Necessary : As necessary
Set value (Use default value)
1
1
192.168.3.18
5001
3times
3sec
3sec
0ms
5.4 PLC Side Setting
5
Setting necessity at GOT
connection
: Not necessary
5 - 71