Mitsubishi Electric GOT2000 Series Connection Manual page 513

■3. Setting Stage No. and Slot No.
(1) When connecting to QCPU (Q mode)
Set an additional stage (16 points
(The GOT cannot be assigned to empty slots of the main base unit or extension base unit.)
POINT POINT POINT
Before setting Stage No. and Slot No.
The PLC CPU recognizes the GOT as follows.
• QCPU (Q mode)
: Intelligent function module of 16 I/O points
• Other than QCPU (Q mode)
: Intelligent function module of 32 I/O points
At the [Detail setting], assign the GOT to an empty I/O slot on the PLC CPU.
10 slots) for GOT connection, and assign a GOT to one of the I/O slots.
Main base unit
Q312B
Extension base unit
Q68B
Stage No. :2 Stage No.
Slot No. :0 Slot No.
POINT POINT POINT
When using the bus extension connector box
Set the Stage No. switch on the bus extension connector box to the same Stage No. as the GOT.
For setting details, refer to the following manual:
➠
A9GT-QCNB Bus Extension Connector Box User's Manual
Extension
stage 1
Stage No. setting
connector
:2 Stage No. :2
:1 Slot No. :2
8.3 GOT Side Settings
8
8 - 35