Connecting To Ethernet Module (Melsec Iq-R Series) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.3

Connecting to Ethernet module (MELSEC iQ-R Series)

This section describes the settings of the GOT and Ethernet module (MELSEC iQ-R Series) in the following case of the
system configuration.
■1. System configuration
*1
■2. [Module parameter] of GX Works3
(1) Module parameter of Ethernet module (MELSEC iQ-R Series)
*1
IP Address
Subnet Mask
Default Gateway
Setting Method of Network No. and Station No.
*2
Network No.
*3
Station No.
5 - 40
5.4 PLC Side Setting
POINT POINT POINT
Ethernet module (MELSEC iQ-R Series)
For details of the Ethernet module (MELSEC iQ-R Series), refer to the following manual.
➠
Manuals of MELSEC iQ-R Series
The Ethernet module is mounted on the base unit slot 0.
The Start XY No. of the Ethernet module is set to "0".
Set [Module parameter] of the port under [Module information].
Item
<GOT>
(Use the default value for settings
other than the following.)
Network No.
PLC No.
IP address
Port No.
Communication format :UDP (fixed)
<Ethernet module>
*1
(Use the default value for settings
other than the following.)
Network No. :1
PLC No. :2
IP address :192.168.3.19
Port No. :5001
Communication format :UDP (fixed)
Set value
192.168.3.19
-
-
Do Not Use IP Address
1
2
:1
:1
:192.168.3.18
:5001
*1
Setting necessity at GOT
connection