Mitsubishi Electric GOT2000 Series Connection Manual page 221

(b) Control system (system B) PLC setting
• Module parameter
Item
Station type
Mode
Station No.
Transmission speed
Parameter setting
(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
When the system switching occurs, CPU (Network No.: 0, PLC station No.: 1) takes over the control of the Ethernet
network system as the control system.
The GOT automatically starts monitoring accroding to the specified system.
Set value
Standby master station
Remote net (Ver.2 mode)
Auto-tracking
Parameter (fixed)
MELSEC iQ-R, RnMT/NC
Host
Network No. 0
Other
Station No.: Station number of the control system
The system (control system/standby system) of the the monitor target can
be speified.
Control system/
Only when checking [Enable Redundant Function] in the following
standby system
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
Check [Enable Redundant Function].
A pairing setting is not required.
➠
4.3 MELSEC Redundant Setting
1
Contents of setting
-
4.1 MELSEC iQ-R Series
4
Model
4 - 45