Connecting To Cc-Link Module (Q Series) With Ver.1 Compatible - Mitsubishi Electric GT1685 Connection Manual

13.4.5 Connecting to CC-Link module
(Q Series) with Ver.1
compatible
This section describes the settings of the GOT and the CC-
Link module (Q Series) with Ver.1 compatible in the
following system configuration.
POINT POINT POINT
CC-Link module (Q Series)
For details of the CC-Link module (Q Series), refer to
the following manual.
CC-Link System Master/Local Module User's
Manual QJ61BT11N

System configuration
■ [Controller Setting] of GT Designer3
■ Setting of the CC-Link communication unit
*1
<CC-Link module>
(Use the default value for the settings other than the following.)
Type : Master station
Station No. : Station No.0
Mode : Remote net (Ver.1 mode)
All connect count : 1
Transmission speed : 156kbps
■ Switch setting of CC-Link module (Q Series)
■ [Network parameter] of GX Developer
*1 The CC-Link module is mounted on the base unit slot 0.
The Start I/O No. of the CC-Link module is set to "0"
13 - 22
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
<GOT>
(Use the default value for settings other
than the following.)
Station type : Intelligent device
station
Station No. : Station No.1
Number of
: Exclusive station 1
stations occupied
Transmission speed : 156kbps

Switch setting of CC-Link module (Q Series)
Set the station number setting switch, transmission
speed / mode setting switch.
QJ61BT11, QJ61BT11N
QJ61BT11N
RUN
MST
SD
ERR.
STATION
NO.
X10
X1
MODE
NC
NC
DA
SLD
DB
(FG)
DG
(1) Station number setting switch
Station number
Description
setting switch
Station number
setting
(master station)
: Necessary
(2) Transmission rate/mode setting switch
Transmission
rate/mode setting Description
switch
Transmission
rate/
mode setting
MODE
(Online:
*1
156kbps)
: Necessary
*1 Specify the same transmission speed as that of the GOT.
POINT POINT POINT
When the switch setting is changed
Turn the PLC CPU OFF then ON again, or reset the
PLC CPU.
L RUN
S MST
RD
L ERR.
(1)
C
(2)
1
2
3
4
5
6
7
Setting necessity at
Set value
GOT connection
0 (fixed)
: As necessary : Not necessary
Setting necessity at
Set value
GOT connection
0
: As necessary : Not necessary