22.7.7
Accessing by the MT Developer
This section explains the procedure to set the FA transparent function of MT Developer with an example of connecting to
motion controller CPU (Q series).
Step 1.
Click [Communication]
Step 2.
Select [USB] in [Serial port].
Step 3.
Click [Detail].
Step 4.
Check-mark either of the following in [PLC side I/F setting of PLC module].
Bus connection
[via GOT(Bus) transparent mode]
Direct CPU connection
[via GOT(direct coupled) transparent mode]
Step 5.
As necessary, select a CPU that is targeted by using the transparent function in [CPU].
22 - 118
22.7 Personal Computer Side Setting
[Communication Setting] in MT Developer.