Connecting To Display I/F (Cnc C70) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.14

Connecting to Display I/F (CNC C70)

This section describes the settings of the GOT and Display I/F (CNC C70) in the following case of the system configuration.
■1. System configuration
■2. IP address settings of CNC C70
(1) Remote monitor tool
IP address
Subnet mask
Gateway address
Port number
Speed auto/10M
5 - 92
5.4 PLC Side Setting
POINT POINT POINT
Display I/F (CNC C70)
For details of the Display I/F (CNC C70), refer to the following manual.
➠
C70 Series SET UP MANUAL
<Q17nNCCPU> (The settings other than the
following are set to the default)
Network No.
PLC No.
IP address
Port No.
Communication format
Item
<GOT> (The settings other than the
following are set to the default)
Network No. : 239
PLC No. : 1
IP address : 192.168.1.1
Port No. : 5001
Communication format : UDP (fixed)
: 239
: 2
: 192.168.1.2
: 5001
: UDP(fixed)
Set value
192.168.1.2
255.255.255.0
0.0.0.0
64758 (fixed)
0 (fixed)
: Necessary
Setting necessity at GOT connection
: As necessary : Not necessary