Mitsubishi Electric GOT2000 Series Connection Manual page 184

(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
Ethernet setting
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
➠
4 - 8
4.1 MELSEC iQ-R Series
MELSEC iQ-R, RnMT/NC
Host
Other
Control
system/
standby
system
➠
5. ETHERNET CONNECTION
➠
4.3 MELSEC Redundant Setting
4.1.1 ■2. (5) Monitoring target change when system switching occurs in a redundant system
Contents of setting
Host (The control system is monitored.)
NW No.: 1
Station No.: Station number of the control system
The system (control system/standby system) of the the monitor target can
be speified.
Only when checking [Enable Redundant Function] in the following
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
Model