Melsec Iq-R, Rnmt/Nc/Rt, Cr800-D (Gt27, Gt25 Only); Melsec Iq-R, Rnmt/Rt, Cr800-D (Gt21 Only); Melsec-Q/Qs, Q17Nd/M/Nc/Dr, Crnd-700; Device Range That Can Be Set - Mitsubishi Electric GOT2000 Series Connection Manual

16.5 Device Range that Can Be Set

For details on the device range that can be used on the GOT, refer to the following.
➠

2.1 MELSEC iQ-R, RnMT/NC/RT, CR800-D (GT27, GT25 only)

➠

2.2 MELSEC iQ-R, RnMT/RT, CR800-D (GT21 only)

➠

2.4 MELSEC-Q/QS, Q17nD/M/NC/DR, CRnD-700

16.6 Precautions
■1. When setting IP address
Do not use "0" and "255" at the end of an IP address.
(Numbers of *.*.*.0 and *.*.*.255 are used by the system)
The GOT may not monitor the controller correctly with the above numbers.
Consult with the administrator of the network before setting an IP address to the GOT and controller.
■2. When connecting to the multiple network equipment (including GOT) in a segment
By increasing the network load, the transmission speed between the GOT and PLC may be reduced.
The following actions may improve the communication performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)
• Reduction of the monitoring points on GOT
16.5 Device Range that Can Be Set
16
16 - 11