Mitsubishi Electric GOT2000 Series Connection Manual page 213

4) Setting of Ethernet module
Set the IP address, Network No., and station number to the port communicating with the GOT in the Ethernet
module.
 When setting the IP address, Network No., and station number in a batch
Set [Communications by Network No./Station No.] to [Enable] and [Setting Method] to [Use IP Address] so
that the third octet of IP address is the network number and the fourth octet is the station number.
(1) In the system configuration example, the network number is 2, and the station number is 1, so the value is
as follows.
IP Address : 192.168.2.1

When setting the IP address, Network No., and station number separately
Set [Communications by Network No./Station No.] to [Enable] and [Setting Method] to [Not Use IP Address],
and set the IP address, network number, and station number separately.
(1) In the system configuration example, the values are as follows.
IP Address : 192.168.0.1
Network No. : 2
Station No. : 1
4.1 MELSEC iQ-R Series
4
4 - 37