Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

Graphic operation terminal

Hide thumbs Also See for GOT2000 Series:

Table of Contents

Communication detail settings

Make the settings according to the usage environment.

■1. Laser Displacement Sensor MH11

Transmission Speed

Timeout Time

Set the value as follows:

Transmission Speed: 15200bps(Default values)

Data Bit: 8bit(Default values)

Stop Bit: 1bit(Default values)

Parity: None(Default values)

Set this item when change the transmission speed used for communication

with the connected equipment. (Default: 115200bps)

Set this item when change the data length used for communication with the

connected equipment. (Default: 8bit)

Specify the stop bit length for communications. (Default: 1bit)

Specify whether or not to perform a parity check, and how it is performed

during communication. (Default: None)

Set the number of retries to be performed when a communication timeout

occurs. (Default: 0time)

Set the time period for a communication to time out. (Default: 3sec)

Set this item to adjust the transmission timing of the communication request

from the GOT. (Default: 0ms)

(1) Communication interface setting by the Utility

The communication interface setting can be changed on the Utility's [Communication setting]

after writing [Controller Setting] of project data.

For details on the Utility, refer to the following manual.

GOT2000 Series User's Manual (Utility)

(2) Precedence in communication settings

When settings are made by GT Designer3 or the Utility, the latest setting is effective.

18.4 GOT Side Settings

Show Quick Links

Table of Contents