Connecting To Melsec Iq-F Series Built-In Ethernet Port Cpu - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.5

Connecting to MELSEC iQ-F Series built-in Ethernet port CPU

This section describes the settings of the GOT and Built-in Ethernet port CPU in the following case of system configuration.
■1. System configuration
*1
5 - 48
5.4 PLC Side Setting
POINT POINT POINT
Connecting to Built-in Ethernet port CPU
For details of Built-in Ethernet port CPU, refer to the following manual.
➠
Manuals of MELSEC iQ-F Series
These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
■3. [Controller Setting] and [Ethernet] of GT Designer3
<GOT>
(Use the default value for settings
other than the following.)
Network No. :1
PLC No. :1
IP address :192.168.3.18
Port No. :5001
Communication format :TCP (fixed)
<Connecting to Built-in Ethernet port
1
CPU>
(The following settings are set to the
default)
Network No. : 1 (virtual)
*1
PLC No. : 2 (virtual)
*1
IP address : 192.168.3.250 (default)
Port No. : 5562 (fixed)
Communication format : TCP (fixed)