Mitsubishi Electric GOT2000 Series Connection Manual page 816

(1) Inverter status monitor
An example with FREQROL-A700 series is shown below.
For the setting items of other than the FREQROL-A700 series, refer to the following manual.
➠
Device name
RS0
RS1
RS2
RS3
RS4
RS5
RS6
RS7
RS8
RS9
RS10
RS11
RS12
RS13
RS14
RS15
*1
(2) Run command
An example with FREQROL-A700 series is shown below. For the setting items of other than the FREQROL-A700
series, refer to the following manual.
➠
Device name
WS0
WS1
WS2
WS3
WS4
WS5
WS6
WS7
*2
WS8
*2
WS9
*2
WS10
*2
WS11
*2
WS12
WS13
WS14
WS15
*1
*2
14 - 60
14.4 Device Range that Can Be Set
User's Manual of the used inverter (communication function (setting item and set data))
Inverter running (RUN)
Forward rotation (STF)
Reverse rotation (STR)
Up to frequency (SU)
Overload (OL)
Instantaneous power failure (IPF)
Frequency detection (FU)
Fault (ABC1)
ABC2
-
-
-
-
-
-
Fault occurrence
The description (function of input terminal) may be changed by the parameter of the inverter side. Check the function of the
inverter used.
➠
Inverter User's Manual (Application) Communication operation and setting
User's Manual of the used inverter (Communication function (Setting item and set data))
Current input selection (AU)
Forward rotation command (STF)
Reverse rotation command (STR)
Low speed operation command (RL)
Middle speed operation command (RM)
High speed operation command (RH)
Second function selection (RT)
Output stop (MRS)
Jog operation (JOG)
Selection of automatic restart after instantaneous power failure (CS)
Start self-holding (STOP)
Reset (RES)
-
-
-
-
The data (function of input terminal) may be changed by the parameter of the inverter side. Check the function of the inverter
used.
➠
Inverter User's Manual (Application) Communication operation and setting
Write a value to parameter Pr.185, Pr.186, Pr.188, or Pr.189 that corresponds to a signal within parentheses.
Doing so issues the corresponding run command (WS8 to WS11).
*1
Description
*1
Description