Connecting To Melsec-Q/L Series Built-In Ethernet Port Cpu (One-To-One Connection) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.6 Connecting to MELSEC-Q/L Series built-in Ethernet port CPU (one-to-
one connection)
This section describes the settings of the GOT and Built-in Ethernet port CPU in the following case of system configuration.
■1. System configuration
(When the PLC side [MELSOFT Connection Extended Setting] is the default value)
For connecting one Built-in Ethernet port QCPU to one GOT, the PLC side settings are not required. Set [Ethernet] for
[Controller Setting] on GT Designer3, and then connect Built-in Ethernet port QCPU to the GOT.
*1
*2
(1) [PLC parameter] of GX Works2
Use the GX Works2 Version1.535H or later.
(a) Built-in Ethernet
IP address
Subnet mask pattern
5 - 52
5.4 PLC Side Setting
POINT POINT POINT
Connecting to Built-in Ethernet port CPU
For details of Built-in Ethernet port CPU, refer to the following manual.
➠
QnUCPU User's Manual (Communication via Built-in Ethernet Port)
➠
MELSEC-L CPU Module User's Manual (Built-In Ethernet Function)
For the settings when using system devices including a hub and a transceiver, refer to the following.
➠
5.4.7 Connecting to MELSEC-Q/L Series built-in Ethernet port CPU (multiple connection)
These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
(2) [Controller Setting] and [Ethernet] of GT Designer3
Item
<GOT>
(The settings other than the
following are set to the default)
Network No. : 1
PLC No. : 1
IP address : 192.168.3.18
Port No. : 5001
Communication : UDP (fixed)
format
<Connecting to Built-in Ethernet port CPU>
(The following settings are set to the default)
*2
Network No. : 1 (virtual)
*2
PLC No. : 2 (virtual)
IP address : 192.168.3.39
Communication : UDP
format
Set value
192.168.3.39
(Use default value)
-
*1
Setting necessity at GOT connection
○
×