Connecting To C Controller Module (Q Series) - Mitsubishi Electric GOT2000 Series Connection Manual

(2) When abnormal communication
At abnormal communication, check the followings and execute the Ping command again.
• Mounting condition of Ethernet communication unit
• Cable connecting condition
• Confirmation of switch and network parameter setting
• Operation state of PLC CPU (faulty or not)
• IP address of GOT specified by Ping command
5.4.9

Connecting to C Controller module (Q Series)

This section describes the settings of the GOT and C Controller module (Q Series) in the following case of the system
configuration.
■1. System configuration
*1
5 - 68
5.4 PLC Side Setting
POINT POINT POINT
Ethernet diagnostics of GX Developer
Ethernet diagnostics of GX Developer is available to a Ping test from the PLC.
For details of Ethernet diagnostics of GX Developer, refer to the following manual.
➠ User's manual of the Ethernet module
POINT POINT POINT
C Controller module (Q Series)
For details of C Controller module (Q Series), refer to the following manual.
➠
C Controller Module User's Manual (Hardware Design, Function Explanation)
These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
■3. [Controller Setting] and [Ethernet] of GT Designer3
<GOT>
(The settings other than the
following are set to the default)
Network No.
PLC No.
IP address
Port No.
Communication
format
<C controller module (Q Series)>
1
(The settings other than the
following are set to the default)
Network No. : 1 (virtual)
PLC No. : 2 (virtual)
IP address : 192.168.3.1
Port No. : 5006(fixed)
Communication : UDP(fixed)
format
<C controller module (Q Series)>
2
(The settings other than the following are
set to the default)
Network No. : 1 (virtual)
*1
PLC No. : 3 (virtual) *1
IP address : 192.168.3.2
Port No. : 5006(fixed)
: UDP(fixed)
Communication
format
: 1
: 1
: 192.168.3.18
: 5001
: UDP(fixed)
*1
*1