Cnc Side Settings - Mitsubishi Electric GOT2000 Series Connection Manual

17.5 CNC Side Settings

17.5.1 MELSECNET/10 connection
■1. Parameter setting
Set parameters related to MELSECNET/10 with MELSEC's peripheral devices in the same way as parameter setting of
MELSEC CPU, and write them on CNC by Personal computer. However, in the case of using the default parameters or
not requiring separate settings due to normal stations, it is not necessary to set the network
(1) Control Station Parameter
If you wish to place the control station in CNC and set the common parameters, set the network parameters by
peripheral device and write them on CNC. An example of parameter setting by GPPW is as follows. Set the first I/O
No. as follows according to the expansion slot to which the unit is inserted.
(a) Start I/O No.
Slot
EXT1
EXT2
(b) Example of GX Developer setting
For details of the parameter setting, refer to the following.
➠
(2) Normal Station Parameter
As for normal stations, it is not necessary to set parameters unless separate settings are required.
The refresh parameters are set and written as required. In this case, the parameter setting of the first I/O No. is the
same as in the case of the control station.
17 - 16
17.5 CNC Side Settings
Start I/O No.
0200
0280
C6/C64/C64T NETWORK INSTRUCTION MANUAL BNP-B2373
EXT1
EXT2