Mitsubishi Electric GOT2000 Series Connection Manual page 321

Graphic operation terminal
Hide thumbs Also See for GOT2000 Series:
Table of Contents

Advertisement

■2. System configuration
(When the PLC side [MELSOFT Connection Extended Setting] is [Use])
Set [Ethernet] for [Controller Setting] on GT Designer3, and then connect Built-in Ethernet port CPU to the GOT.
*1
Use the product whose the first five digits of the serial No. for QnUD(P)VCPU is "17052" or later.
(1) [PLC parameter] of GX Works2
Use the GX Works2 Version1.535H or later.
(a)
Built-in Ethernet port
IP address
Subnet mask pattern
Default router IP address
Communication data code
Enable online change
(FTP, MC protocol)
Disable direct connection to MELSOFT
Do not respond to search for CPU (Built-in Ethernet
port) on network
Open settings
FTP settings
Time settings
MELSOFT Connection Extended Setting
(b)
Open settings
The setting is required for all the connected GOTs.
Protocol
Open system
(c)
MELSOFT Connection Extended Setting
MELSOFT Connection Extended Setting
Network No.
Station No.
<Connecting to Built-in Ethernet port CPU>
(The following settings are set to the default)
Network No.
PLC No.
IP address
Communication format
Item
Item
Item
<GOT>
(The settings other than the
following are set to the default)
Network No.
: 1
PLC No.
: 1
IP address
: 192.168.3.18
Port No.
: 5001
Communication format
: UDP (fixed)
*1
: 1
: 2
: 192.168.3.39
: UDP
Set value
192.168.3.39
(Use default value)
-
-
(Use default value)
Refer to (b).
(Use default value)
Refer to (c).
: Necessary
MELSOFT connection
Set value
Use
1
2
5.4 PLC Side Setting
Setting necessity at GOT connection
: As necessary
: Not necessary
Set value
UDP
Setting necessity at GOT connection
5 - 55
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents