Mitsubishi Electric GOT2000 Series Connection Manual page 188

(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
Ethernet setting
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
• Redundant system-1
When the system switching occurs, CPU (PLC station No.: 2) takes over the control of the Ethernet network
system as the control system.
The GOT automatically starts monitoring accroding to the specified system.
• Redundant system-2
When the system switching occurs, CPU (PLC station No.: 4) takes over the control of the Ethernet network
system as the control system.
The GOT automatically starts monitoring accroding to the specified system.
4 - 12
4.1 MELSEC iQ-R Series
MELSEC iQ-R, RnMT/NC
Host Host (The control system is monitored.)
NW No.: 1
Other
Station No.: Station number of the control system
The system (control system/standby system) of the the monitor target can
be speified.
Control system/
Only when checking [Enable Redundant Function] in the following
standby system
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
➠
5. ETHERNET CONNECTION
➠
4.3 MELSEC Redundant Setting
Contents of setting Model