Mitsubishi Electric GOT2000 Series Connection Manual page 331

Item
Initial settings
Open settings
Router relay parameter
Station No.<->IP information
FTP Parameters
E-mail settings
Interrupt settings
*4
Redundant settings
Routing Parameters
*1 When using Q170MCPU or Q170MSCPU(-S1), set the start I/O No. to 0070H.
*2 Specify the same network No. as that of the GOT.
*3 Do not set the same station No. as that of the GOT.
*4 Set when using Ethernet module in a redundant QnPRHCPU system.
(2) Operation setting
Item
*1
Communication data code
IP address
*1
Initial timing
Send frame setting
*1
Enable Write at RUN time
TCP Existence confirmation setting
*1 Because port No. 5001 is fixed, these items operate at the following setting without relations to the setting given here.
• Communication date code: [Binary code]
• Initial timing: "Always wait for OPEN" (Communication is applicable while stopping the PLC CPU.)
• Enable Write at RUN time: [Enable Write at RUN time] (Writing Data is applicable while running the PLC CPU.)
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF
and then ON or resetting.
Set value
(Use default value)
Refer to (3)
: Necessary : As necessary
Set value
(Use default value)
192.168.3.19
(Use default value)
: Necessary : As necessary
5.4 PLC Side Setting
Setting necessity at GOT
connection
: Not necessary
Setting necessity at GOT
connection
: Not necessary
5 - 65
5