Mitsubishi Electric GOT2000 Series Connection Manual page 250

■4. CC-Link connection (Via G4) (Connection to the CC-Link module mounted on redundant
type extension base unit)
This section explains the CC-Link connection (Via G4) for connecting the GOT to the CC-Link module mounted on the
redundant type extension base unit via the AJ65BT-G4-S3.
The following shows an example of connecting the GOT to the AJ65BT-G4-S3 of the CC-Link network.
Control system
(System A)
Redundant type extension base unit
Network No. 0, Station No. 1
(AJ65BT-G4-S3)
(1) Connection method
Connect the AJ65BT-G4-S3 of the CC-Link network to the GOT.
For details, refer to the following.
➠
(2) GT Designer3 setting
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
MELSEC Redundant Setting
(3) Monitoring target change when system switching occurs in a redundant system
When the system switching occurs, the GOT automatically changes the monitoring target to the PLC CPU switched
to the control system.
4 - 74
4.2 MELSEC Q Series
Monitor target
13. CC-Link CONNECTION (Via G4)
MELSEC-QnA, MELDAS C6*
Host
Do not set the item.
Standby system
(System B)
Network No. 0, Station No. 0
(Master station)
CC-Link
connection
GOT
Settings Model