Mitsubishi Electric GOT2000 Series Connection Manual page 356

Communication Data Code
Disable direct connection to MELSOFT
Do not respond to search for CPU on network
*1 The default value of IP address is 192.168.1.250. Set the IP address corresponding to the system configuration.
(2) Open settings
Protocol
Open System
■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
(2) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
5 - 90
5.4 PLC Side Setting
Item
POINT POINT POINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn the PLC CPU OFF then back ON again.
Item
POINT POINT POINT
When connecting to multiple GOTs and peripheral devices
The number of protocols equivalent to that of the GOTs
and devices must be set.
Item
Item
Setting
(Use default value.)
:Required
Setting
TCP
MELSOFT connection
Setting (Use default value.)
Setting (Use default value.)
Setting
(with GOT connected)
:Set if necessary :Not required
Setting
(with GOT connected)
1
1
192.168.3.18
5019
3times
3sec
3sec
0ms
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014