Connecting To Peripheral I/F (Built-In Ethernet Port Motion Controller Cpu) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.16 Connecting to PERIPHERAL I/F (Built-in Ethernet port Motion
Controller CPU)
This section describes the settings of the GOT and Built-in Ethernet port Motion Controller CPU in the following case of
system configuration.
■1. System configuration
Leave the Built-in Ethernet port Motion Controller CPU settings as default in the following system configuration.
*1 For the settings when using system devices including a hub and a transceiver, refer to the following.
➠
*2 These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
POINT POINT POINT
(1) GOT type setting
For details, refer to the following.
➠ 1.1.1 Setting connected equipment (Channel setting)
(2) Setting [Controller Type]
(2) CPU No. specification of Q170MCPU and Q170MSCPU(-S1)
Set whether to monitor the PLC CPU area or the Motion CPU area of Q170MCPU or
Q170MSCPU(-S1), in the CPU No. specification.
For details, refer to the following.
➠
5.5 Precautions
(3) PLC type of GX Works2/GX Developer
When creating a program, set the following PLC type:
• For Q173D(S)CPU/Q172D(S)CPU
QnUD(E)(H)CPU
• For Q170MCPU and Q170MSCPU(-S1) Q03UDCPU
Q03UDCPU
(4) Built-in Ethernet port CPU
For details of Built-in Ethernet port CPU, refer to the following manual.
➠
User's Manual of Q173D(S)CPU/Q172D(S)CPU , Q170MCPU, and Q170MS(-
S1)CPU
<Connecting to Built-in Ethernet port CPU>
(The following settings are set to the default)
Network No.
PLC No.
IP address
Open system
5.4.7 Connecting to MELSEC-Q/L Series built-in Ethernet port CPU (multiple connection)
■3. [Controller Setting] and [Ethernet] of GT Designer3
<GOT>
(The settings other than the
following are set to the default)
Network No. : 1
PLC No. : 1
IP address : 192.168.3.18
Port No. : 5001
Communication : UDP (fixed)
format
*1
*2
: 1 (virtual)
*2
: 2 (virtual)
: 192.168.3.39
: MELSOFT connection (fixed)
5.4 PLC Side Setting
5
5 - 99