Mitsubishi Electric GOT2000 Series Connection Manual page 312

IP Address
Subnet Mask
Default Gateway
External Device Configuration
*1 Set the IP address corresponding to the CH No. to be used to connect to the GOT.
■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT NET No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
(2) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
5 - 46
5.4 PLC Side Setting
*1
Item
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting Built-in Ethernet port CPU to a GOT, the setting items for the network No.
and station No. do not exist at the PLC side. However, these virtual values must be set on the
GOT side. Therefore, set the network No. and station No.
Set the network No. that does not exist on the network system and any station No.
Item
Item
Set value
-
-
-
-
: Necessary
Set value (Use default value)
Set value (Use default value)
Setting necessity at GOT connection
: As necessary : Not necessary
1
1
192.168.3.18
5001
3times
3sec
3sec
0ms
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014