Mitsubishi Electric GOT2000 Series Connection Manual page 699

■3. Parameter setting
There are two methods for the parameter setting: perform the setting from [Network parameter] of GX Developer and
the sequence program.
Performing it from the [Network parameter] of the GX Developer can be set only when the PLC CPU and the CC-Link
module use the function version B or later.
(1) Setting from [Network parameter] of GX Developer
(a) Network parameter
No. of boards in module
Start I/O No.
Type
All connect count
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special register (SW)
Retry count
Automatic reconnection station count
Wait master station No.
PLC down select
Scan mode setting
Delay information setting
Station information setting
Item Set value
1
0000H
Master station (fixed)
1
X400
Y400
D300
D200
B0
W0
(Use default value)
Refer to (2)
: Necessary : As necessary
12.4 PLC Side Setting
Setting necessity at GOT
connection
12
: Not necessary
12 - 57