Mitsubishi Electric GOT2000 Series Connection Manual page 359

(2) CNC monitor
Item
IP address
Subnet mask
Gateway address
Port number
Speed auto/10M
(3) Communication check
The CNC C70 can communicate with the GOT when INIT.LED of the CNC C70 is lit.
For confirming the communication state, refer to the following.
➠
■ Checking communication state of CNC C70
■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
(2) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
Item
Item
Set value Setting necessity at GOT connection
192.168.1.2
255.255.255.0
0.0.0.0
64758 (fixed)
0 (fixed)
: Necessary : As necessary
Set value (Use default value)
259
1
192.168.1.1
5001
3times
3sec
3sec
0ms
Set value (Use default value)
192.168.1.1
255.255.255.0
0.0.0.0
5015
5014
5.4 PLC Side Setting
5
: Not necessary
5 - 93