Engine; Removal - New Holland W190C Tier 4 Service Manual

Removal

STEP 1
Park machine on a level surface and lower bucket to
ground. Put articulation lock in LOCKED position.
STEP 2
Stop engine. Actuate brake pedal several times to
discharge brake accumulators. Put key switch in ON
position and move loader control lever back and forth
at lea st 30 times to release any p ressure from
hydraulic circuit. Put key switch in OFF position.
STEP 3
Slowly loosen the filler cap for hydraulic reservoir to
release air pressure in hydraulic reservoir.
STEP 4
The master and hood raise switch are located by the
battery box. Raise the hood with the hood lift motor.
Put master disconnect switch in OFF position.
Remove both ba tte r y co ve rs and d isconn ec t
batteries from the machine.

ENGINE

STEP 5
Put a 30 liter (32 U.S. quart) container below radiator
drain. Remove radiator cap. Remove cap and drain
BD03A040
coolant into container. Install cap after coolant has
drained. Install radiator cap.
STEP 6
Put a 15.1 liter (16 U.S. quart) container below
engine oil drain. Remove cap and drain oil into
container. Install cap after oil has drained.
NOTE: After draining oil disconnect drain hose from
frame for removal with engine.
STEP 7
Double up a nylon lifting strap (1) and slide through
the exhaust stack (2) on the hood.
BD06F108
2000-3
BD02N160
BD02N160