Reattaching Cylinders After Repair With Boom Resting On Boom Lock Pins - New Holland LS120 Repair Manual

SECTION 00 - GENERAL INFORMATION
REATTACHING CYLINDERS AFTER
REPAIR WITH BOOM RESTING ON BOOM
LOCK PINS
1 . Support the rod end of cylinders, 1 , off the boom
upper links, 2, to align with main boom cylinder
pivot pin holes, 3.
2. Operator sitting in the Operator's seat with seat
belt buckled.
3. Start the engine and hydraulically extend
cylinder rods to align cylinder with pivot pin, 1.
Stop engine.
4. Turn the ignition key to the "ON" position. Foot
controls, press the toe of the left foot pedal, boom
control, into the· boom float position, turn the
ignition key to the "OFF" position.
5. If cylinder and boom are not properly aligned, use
a pry bar to align cylinder and boom;
6. Install pivot pin, 1, and secure with retaining
hardware, 2. Torque bolts to 38 N·m (28
ft.
lbs.).
7. Start the engine and hydraulically extend the
second cylinder rod to align cylinder with pivot
pin. Stop engine.
8. If cylinder and boom are not properly aligned, sit
in the operator's seat with seat buckled, turn the
ignition key to the "ON" position.
9. Move the boom control to the "DETENT' (float)
position and turn the ignition key to the "OFF"
position.
10. Use a pry bar and align cylinder with boom and
install pivot pin, 1, and retaining hardware, 2, and
torque to 38 N·m (28
ft.
lbs.).
00-18
15
16