Show Dcb - Dell Z9500 Reference Manual

Version
9.7(0.0)
Usage
•
Information
•

show dcb

Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-
enabled queues.
Syntax
Show dcb linecard <0-2> port-set <0-3>
Parameters
unit number
port-set
number
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Data Center Bridging (DCB)
Description
Introduced on the Z9500.
When you configure lossless queues on an interface, PFC priority configuration
is not allowed on the dcb-input profile applied on the interface.
The maximum number of lossless queues globally supported on the switch is
two.
The following lists the dot1p priority-queue assignments.
dot1p Value in the Description heading
Incoming Frame
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Enter the linecard number. The range is from 0 to 2.
Enter the port-set number. The range is from 0 to 3.
Description
Introduced on the Z9500
581