DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The password affected by this command includes the user account password, enable password, and the
authentication password.
Example
This example shows how to enable the encryption of the password before stored in the configuration file.
Switch# configure terminal
Switch(config)# service password encryption
Switch(config)#
5-15 show terminal
This command is used to obtain information about the terminal configuration parameter settings for the
current terminal line. Use this command in any EXEC mode or any configuration mode.
show terminal
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the terminal configuration parameters for the current
terminal line
Example
This example shows how to display information about the terminal configuration parameter settings for
the current terminal line.
Switch# show terminal
Terminal Settings:
Length: 24 lines
Width: 80 columns
Default Length: 24 lines
Default Width: 80 columns
Baud rate: 9600 bps
Switch#
5-16 show users
This command is used to display information about the active lines on the switch.
82