D-Link DXS-3600 Series Reference Manual page 349

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no next-server
Parameters
IP-ADDRESS
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the server IP address for the client to boot the image. The server is typically
a TFTP server. Only one boot server can be specified.
Example
This example shows how to configure 10.1.1.1 as the IP address of next server in the DHCP client's boot
process in the pool named pool1.
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# next-server 10.1.1.1
21-23 network
This command is used to configure the network with its associated mask for a DHCP address pool. Use
the no command to remove the network.
network {NETWORK-ADDRESS MASK | NETWORK-ADDRESS/PREFIX-LENGTH}
no network
Parameters
NETWORK-ADDRESS
MASK
PREFIX-LENGTH
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Specifies the boot server IP address for the client to get the boot file.
Specifies the network address for the address pool.
Specifies the bits that mask the network part of the address.
Specifies the prefix length of the network. It is an alternative way to
specify the network mask.
349