D-Link DXS-3600 Series Reference Manual page 214

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the routes that match the specified community string. If no option is
specified for the command, the information for IPv4 unicast address family will be displayed.
Example
This example shows how to display the display the routes that match the 111:12345 community string.
Switch#show ip bgp ipv4 unicast community 111:12345
BGP table version is 716977, local router ID is 192.168.32.1
Status codes:s suppressed,d damped,h history,* valid,> best,i – internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
*> 0.10.10.0/24
*> 10.10.20.0/24
* 10.20.10.0/24
Switch#
Display Parameters
BGP table version
local router ID
Status codes
Origin codes
Network
Next Hop
Metric
LocPrf
Weight
Path
Next Hop Metric LocPrf
172.16.10.1 0
172.16.10.1 0
172.16.10.1 0
The version number of the table. This number is incremented
whenever the table changes.
The IP address of the router.
The status of the path. It can be one of the following values:
s - The path is suppressed.
d - The path is dampened.
h - The entry is a history path.
* - The path is valid.
> - The entry is the best path to that network.
i - The path was learned via an iBGP session.
The origin of the path. It can be one of the following values:
i - Path originated from IGP.
e - Path originated from EGP.
? - Origin of the path is not clear.
The IP address of a network.
The IP address of the next router IP address of the next router to
forward the packet.
The value of the inter-autonomous system metric.
The local preference value.
The weight of the route.
The AS path to the destination network.
214
Weight Path
300 10 i
300 10 i
300 10 i