D-Link DXS-3600 Series Reference Manual page 891

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
MINUTES
type
absolute
inactivity
Default
By default, the port security aging feature is disabled.
The default time is 0 minutes.
The default aging type is absolute.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to disable the ageing or set the ageing time for auto-learned dynamic secured entries.
In order for the inactivity setting to take effect, the FDB table ageing function must be enabled.
Example
This example shows how to apply the aging time for automatically learned secure MAC addresses for
interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# switchport port-security aging 1
Switch(config-if)#
This example shows how to configure the port security aging time type for interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# switchport port-security aging type inactivity
Switch(config-if)#
74-5 port-security limit
This command is used to configure the maximum secure MAC address number on the system or on the
specified VLAN. Use the no form of this command to reset to the default setting.
port-security limit {global | vlan VLAN-ID [, | -]} VALUE
no port-security limit {global | vlan VLAN-ID [, | -]}
Specifies the aging time for the auto-learned dynamic secured address
on this port. Its range is from 1 to 1440 in minutes.
Specifies to set the aging type.
Specifies to set absolute aging type. All the secure addresses on this
port age out exactly after the time specified and is removed from the
secure address list. This is the default type.
Specifies to set the inactivity aging type. The secure addresses on this
port age out only if there is no data traffic from the secure source
address for the specified time period.
891