D-Link DXS-3600 Series Reference Manual page 50

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Only one access list of the same type can be applied to the same interface; but access lists of different
types can be applied to the same interface. The association of an access group with an interface will
consume the filtering entry resource in the switch controller. If the resource is insufficient to commit the
command, then an error message will be displayed.
There is a limitation on the number of port operator resources. If applying the command exhausts the
available port selectors, then an error message will be displayed.
Example
This example shows how to specify the IPv6 access list "ip6-control" as an IP access group for eth3/0/3.
Switch# configure terminal
Switch(config)# interface eth3/0/3
Switch(config-if)# ipv6 access-group ip6-control in
The remaining applicable IPv6 related access entries are 2500
The remaining applicable port operators are 10
Switch(config-if)#
4-10 ipv6 access-list
This command is used to create or modify an IPv6 access list. This command will enter into IPv6 access-
list configuration mode. Use the no form of this command to remove an IPv6 access list.
ipv6 access-list [extended] NAME [NUMBER]
no ipv6 access-list [extended] {NAME | NUMBER}
Parameters
NAME
NUMBER
extended
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The name must be unique among all access lists. The characters used in the name are case sensitive. If
the access list number is not specified, the biggest unused number in the range of the IPv6 access list
numbers will be assigned automatically.
Example
Specifies the name of the IPv6 access list to be configured. The
maximum length is 32 characters.
(Optional) Specifies the ID number of the IPv6 access list. For
standard IPv6 access lists, this value is from 11000 to 12999. For
extended IPv6 access lists, this value is from 13000 to 14999.
(Optional) Specifies that without this option the IPv6 access list is a
standard IPv6 access list. When using the extended option, the IPv6
access list is an extended IPv6 access list and more fields can be
chosen for the filter.
50