D-Link DXS-3600 Series Reference Manual page 141

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Use this command to create a static IPv6 neighbor cache entry on an interface. The static entry will be
either in the REACHABLE state, if the interface is UP, or in the INCOMPLETE state if the interface is
down. The reachable detection process will not be applied to the static entries.
The clear ipv6 neighbors command will clear the dynamic neighbor cache entries. Use the no ipv6
neighbor command to delete a static neighbor entry.
Example
This example shows how to create a static ipv6 neighbor cache entry.
Switch# configure terminal
Switch(config)# ipv6 neighbor fe80::1 vlan1 00-01-80-11-22-99
Switch(config)#
9-18 show ipv6 general-prefix
This command is used to display IPv6 general prefix information.
show ipv6 general-prefix [PREFIX-NAME]
Parameters
PREFIX-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information of IPv6 general prefixes.
Example
This example shows how to display all IPv6 general prefix on the system.
Switch# show ipv6 general-prefix
IPv6 prefix yy
Acquired via DHCPv6 PD
vlan1: 200::/48
Valid lifetime 2592000, preferred lifetime 604800
Apply to interfaces
vlan2: ::2/64
Total Entries: 1
Switch#
(Optional) Specifies the name of the general prefix to be displayed. If
the general prefix name is not specified, all general prefixes will be
displayed. The general prefix name can be up to 32 characters.
141