D-Link DXS-3600 Series Reference Manual page 338

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
IDENTIFIER
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is valid for manual binding entries in a DHCP address pool. The client identifier is
formatted by media type and the MAC address. Only one manual binding entry can be specified in a
DHCP address pool. With a manual binding entry, the IP address can be either be bound with a client-
identifier or bound with the hardware address of the host.
Use the client-identifier command and the host command to specify the manual binding entry based on
the client-identifier in the DHCP packet.
Example
This example shows how a DHCP address pool "pool1" is created with a manual binding entry which
binds the IP address 10.1.2.3/24 with client ID 0x01524153203124.
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# client-identifier 01524153203124
Switch(config-dhcp-pool)# host 10.1.2.3/24
Switch(config-dhcp-pool)#
21-8 default-router
This command is used to specify default routers for the DHCP client. Use the no form of this command to
remove the default router.
default-router IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8]
no default-router IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8]
Parameters
IP-ADDRESS
IP-ADDRESS2...IP-
ADDRESS8
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Specifies a DHCP client identifier in hexadecimal notation.
Specifies the IP address of the default router for the DHCP client.
Specifies multiple IP addresses, separated by spaces. Up to eight
addresses can be specified.
338