D-Link DXS-3600 Series Reference Manual page 348

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# netbios-node-type h-node
Switch(config-dhcp-pool)#
21-21 netbios-name-server
This command is used to specify WINS name servers for the Microsoft DHCP client. Use the no form of
this command to remove the configuration of specific WINS servers.
netbios-name-server IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8]
no netbios-name-server IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8]
Parameters
IP-ADDRESS
IP-ADDRESS2...IP-
ADDRESS8
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the WINS name server IP addresses that that are available to the
Microsoft client. Up to eight servers can be specified. Servers are listed in the order of preference. If
name servers are already configured, the name server configured later will be added to the default
interface list.
Example
This example shows how to configure 10.1.1.100 and 10.1.1.200 as WINS servers for the address pool
"pool1".
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# netbios-name-server 10.1.1.100 10.1.1.200
Switch(config-dhcp-pool)#
21-22 next-server
This command is used to specify the BOOT server for the DHCP client. Use the no form of this command
to remove boot servers.
next-server IP-ADDRESS
Specifies the WINS name server IP address for the DHCP client.
Specifies multiple IP addresses, separated by spaces. Up to eight
servers can be specified.
348