D-Link DXS-3600 Series Reference Manual page 725

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
untagged
INTERFACE-ID
Default
No receiver or source port is a member of any multicast VLAN.
Command Mode
Multicast VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The member port of a multicast VLAN can be either a receiver port or a source port. Receiver ports are
ports connected to subscribers. Source ports are ports that the multicast traffic source comes from.
A multicast VLAN can have more than one source ports. If IGMP/MLD report packets come from a source
port, Multicast VLAN will not learn the IGMP/MLD group for this report, but only forward the packets to
other source ports in the Multicast VLAN.
A port can be the receiver port of multiple multicast VLANs at the same time.
There are some restrictions when configuring receiver and source ports for a Multicast VLAN.
•
In a single Multicast VLAN, a port cannot be a receiver port and a source port at the same time.
•
The source ports in a single Multicast VLAN must all be either tagged members or untagged
members.
•
Tagged receiver ports cannot overlap with untagged receiver ports in a single Multicast VLAN.
•
Source ports in one Multicast VLAN cannot overlap with receiver ports between two Multicast
VLANs.
•
Tagged source ports cannot overlap untagged source ports between two Multicast VLANs.
Example
This example shows how to configure ports eth1/0/1 to eth1/0/4 as tagged receiver ports in multicast
VLAN 100.
Switch# configure terminal
Switch(config)# mvlan
Switch(config)# mvlan 100
Switch(config-mvlan)# member receiver tagged eth1/0/1-4
Switch(config-mvlan)#
65-5 name
This command is used to specify the name of a multicast VLAN. Use the no form of this command to
reset the VLAN name to the default VLAN name.
name VLAN-NAME
no name
Parameters
Specifies that if the port is an untagged member, then the packets will
be forwarded in the untagged form.
Specifies an interface or an interface list. No spaces are allowed
before and after the comma. The interface can be a physical interface
or a port-channel.
725