D-Link DXS-3600 Series Reference Manual page 291

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
14-35 show cfm pkt-cnt interface
This command is used to display the CFM packet's RX/TX counters of the specified physical interface.
show cfm pkt-cnt interface [INTERFACE-ID [, | -]] [rx] [tx]
Parameters
INTERFACE-ID
,
-
rx
tx
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
The command is used to display physical interface's packet counters. If interfaces are not specified, then
counters for all interfaces are displayed. If only the physical interface is specified, it will display both the
RX and TX packet counters of the specified physical interface. If the RX/TX type is specified, it will display
the RX or TX packet counters of all physical interfaces.
Example
This example shows how to display packet counters of eth 1/0/1.
Switch# show cfm pkt-cnt interface eth1/0/1
interface status TLV was present in the last CCM received.
Up: The interface is ready to pass packets.
Down: The interface cannot pass packets.
Testing: The interface is in some test mode.
Unknown: The interface status cannot be determined for some
reason.
Dormant: The interface is not in a state to pass packets but is in a
pending state, waiting for some external event.
Notpresent: Some component of the interface is missing.
Lowerlayerdown: The interface is down due to state of the lower layer
interfaces.
(Optional) Specifies the interface ID to display. The allowed interfaces
only include physical interfaces.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
(Optional) Specifies the RX counters of the specified physical
interface.
(Optional) Specifies the TX counters of the specified physical interface.
291