D-Link DXS-3600 Series Reference Manual page 263

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-cfm-mep)#
14-3 ccm enable
This command is used to enable the CFM Continuity Check Message (CCM) function. To disable this
function, use the no command.
ccm enable
no ccm enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the CFM CCM function.
Example
This example shows how to enable the CFM CCM function.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# ccm enable
Switch(config-cfm-mep)#
14-4 ccm interval
This command is used to configure the CCM interval for a Maintenance Association (MA). Use the no
form of the command to reset to the default setting.
ccm interval INTERVAL
no ccm interval
Parameters
INTERVAL Specifies the CCM interval. It can be one of the following values.
100 ms: 100 milliseconds. It is not recommended in CFM software
mode as it may exhaust CPU utilization.
1sec: One second.
263