D-Link DXS-3600 Series Reference Manual page 754

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
67-13 loop-detection
This command is used to enable loop detection. Use the no form of this command to disable loop
detection.
loop-detection
no loop-detection
Parameters
None.
Default
By default, this option is disabled.
Command Mode
LDP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable LDP loop detection. LDP loop detection makes use of the Path Vector and
Hop Count TLVs carried by the label request and label mapping messages to prevent looping of LDP
messages. If enabled, LDP does not send the LDP message that violates the path vector check or hop
count check to next hop.
Example
This example shows how to enable LDP loop detection.
Switch# configure terminal
Switch(config)# mpls ldp configuration
Switch(config-ldp)# loop-detection
Warning: The configuring will lead to LDP sessions restart.
Switch(config-ldp)#
67-14 lsp-control-mode
This command is used to configure the Label-Switched Path (LSP) control mode. Use the no form of this
command to restore the default value.
lsp-control-mode {independent | ordered}
no lsp-control-mode
Parameters
independent
ordered
Default
Specifies the independent control mode.
Specifies the ordered control mode.
754