D-Link DXS-3600 Series Reference Manual page 489

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch#
Display Parameters
Profile
Inst ID
RingType
Node Type
Status
Port-State
37-16 activate
This command is used to activate an ERP instance. Use the no activate command to deactivate an ERP
instance.
activate
no activate
Parameters
None.
Default
By default, this option is disabled.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to activate an ERP instance. The ring ports, APS channel, and profile must be
configured first before an ERP instance can be activated. An ERP instance that is activated will be put in
non-operational state if the following conditions occur.
•
The configured APS channel VLAN does not exist.
•
The configured ring ports are not the tagged member port of the APS channel VLAN.
In addition to these configurations, the configuration of service protected VLANs and RPL related settings
are fundamental for operation of an ERP instance.
Example
This example shows how to activate the major ring instance 1.
The profile associated with the ring instances.
The instance identifier of the ERP instance.
Indicates either the major ring or sub-ring.
The RPL owner or neighbor.
The current status of the ERP instance. It can be one of the following
values:
Deactivated: The ERP instance is deactivated.
Init: The instance is initializing.
Idle: The instance is in the normal state. The RPL port is blocked.
Protection: The instance detects failure at some ring port. The RPL
port is restored to protect the port.
The current ring ports state. (- / Forwarding / Blocked)
489