D-Link DXS-3600 Series Reference Manual page 559

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
loopback1 is enabled, link status is up
Interface type: Loopback
Interface description: Loopback 1 for MIS
Switch#
This example shows how to display the NULL interface information for interface null0.
Switch# show interfaces null0
Null0 is enabled, link status is up
Interface type: Null
Interface description: Null0 for MIS
Switch#
This example shows how to display the interface information for eth1/0/1.
Switch# show interfaces eth1/0/1
eth1/0/1 is enabled, link status is up
Interface type: 1000BaseTx
Interface description: Physical Ethernet port 1/0/1
MAC Address: 00-03-04-29-00-00
Auto-duplex, auto-speed, auto-mdix
Send flow-control: on, receive flow-control: on
Send flow-control oper: on, receive flow-control oper: on
Full-duplex, 1Gb/s
Maximum transmit unit:1536 bytes
RX rate: 0 bytes/sec, TX rate: 0 bytes/sec
RX bytes: 0, TX bytes: 0
RX rate: 0 packets/sec, TX rate: 0
RX packets: 0, TX packets: 0
RX multicast: 0, RX broadcast: 0
RX CRC error: 0, RX undersize: 0
RX oversize: 0, RX fragment: 0
RX jabber: 0, RX dropped Pkts: 0
RX MTU exceeded: 0
TX CRC error: 0, TX excessive deferral: 0
TX single collision: 0, TX excessive collision: 0
TX Late collision: 0, TX collision: 0
Switch#
This example shows how to display the interface information for management port 0.
Switch# show interfaces mgmt0
mgmt0 is enabled, link status is up
Interface type: Management port
Interface description: mgmt_ipif for MIS
Switch#
559