D-Link DXS-3600 Series Reference Manual page 888

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
INTEFACE-ID
,
-
address
vlan VLAN-ID
.
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the current port security settings.
Example
This example shows how to display the port security settings of interfaces eth1/0/1 to eth1/0/3.
Switch# show port-security interface eth1/0/1-3
D:Delete-on-Timeout
Interface
No.
------------ ---- ---- -------- -------------------- ---- -------- ------------
eth1/0/1
eth1/0/2
eth1/0/3
Total Entries: 3
Switch#
74-3 switchport port-security
This command is used to configure the port security settings to restrict the number of users that are
allowed to gain access rights to a port. Use the no form of this command to disable port security or to
delete a secure MAC address.
Specifies the ID of the interface to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to display all the secure MAC addresses, including both
configured and learned entries.
(Optional) Specifies to display port security settings for the VLAN.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is allowed before and after the
comma.
(Optional) Specifies a range of VLANs. No space is allowed before and
after the hyphen.
P:Permanent
Max Curr Violation
No. No. Act.
5 2 Restrict
10 10 Shutdown
10 0 Shutdown
Violation Security Admin
Count Mode
0 D
0 D
0 P
888
Current
State State
Enabled Forwarding
Enabled Err-disabled
Disabled -