D-Link DXS-3600 Series Reference Manual page 110

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Global Configuration Mode or Server Group Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to specify the interface whose IPv6 address will be used as the source IPv6
address for sending RADIUS packets. If the source interface is specified in both the global configuration
mode and group server configuration mode, the source interface specified in group server configuration
mode take precedence.
When the server is located at the Out-Of-Band Management Port, the user should specify the interface ID
of Out-Of-Band Management Port as the source interface in order to send the request packet to the
management port.
Example
This example shows how to set VLAN100, whose IPv6 address will be used as the source IPv6 address,
for sending RADIUS packets.
Switch#configure terminal
Switch(config)# ipv6 radius source-interface vlan100
7-22 login authentication
This command is used to configure the method list used for login authentication via a specific line. Use
the no form of the command to reset back to the default method list.
login authentication {default | METHOD-LIST}
no login authentication
Parameters
default
METHOD-LIST
Default
By default, the default method list is used.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
For authentication via the method list to take effect, enable AAA first by using the aaa new-model
command. Create the method list first by using the aaa authentication login command. If the method list
does not exist, the command does not take effect and the authentication will be done via the default login
method list.
When aaa new-model is enabled, the default method list is used for authentication.
Example
Specifies to authenticate based on the default method list.
Specifies the name of the method list to use.
110