Power Saving Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

75. Power Saving Commands

75-1 dim led
This command is used to disable the port LED function. Use the no form of the command to restore the
LED function.
dim led
no dim led
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to turn off the port LED function. Use the no form of the command to restore the LED
function. When the port LED function is disabled, LEDs used to illustrate port status are all turned off to
save power.
Example
This example shows how to disable the port LED function:
Switch# configure terminal
Switch(config)# dim led
Switch(config)#
75-2 power-saving
This command is used to enable individual power saving functions. Use the no form of the command to
disable these functions.
power-saving {link-detection | length-detection | port-shutdown | dim-led | hibernation}
no power-saving {link-detection | length-detection | port-shutdown | dim-led | hibernation}
Parameters
link-detection
length-detection
dim-led
Specifies that power saving will be applied by link status.
Specifies that power saving will be applied by cable length detection.
Specifies that power saving will be applied by scheduled dimming
LEDs.
893