D-Link DXS-3600 Series Reference Manual page 183

Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs Also See for DXS-3600 Series:
Table of Contents

Advertisement

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, the maximum number of prefix value is 16000.
The threshold value is 75 percent.
Command Mode
Router Configuration Mode.
Address Family Configuration Mode (IPv4 unicast, VPNv4 and VRF).
Command Default Level
Level: 12.
Usage Guideline
The user can use the maximum-prefix command to configure a maximum number to restrict the number
of routing prefixes that can be accepted from the specified peer. To use the command, the user should
determine the maximum number of prefixes based on the amount of available system resources.
When the maximum number is defined for a session, the system will monitor whether the current prefix
number exceed the threshold. When the threshold is exceeded, if the option warning-only is not
specified, the session will be terminated and a system message will be generated to notify the user of the
event. If the warning-only option is specified, a system message will be generated to notify the user of
the event. If a session is terminated due to exceeding of the maximum prefixes, the session will not be
rebuilt unless the clear ip bgp command is issued to do a hard reset on the session.
Example
This example shows how to set the maximum prefixes that will be accepted from the neighbor,
192.168.1.1 to 1000.
Switch# configure terminal
Switch(config)# router bgp 40000
Router(config-router)# network 192.168.0.0
Router(config-router)# neighbor 192.168.1.1 maximum-prefix 1000
10-46
neighbor next-hop-self
This command is used to configure the router as the next hop for a BGP-speaking neighbor or peer-group.
To disable this feature, use the no form of this command.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} next-hop-self
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} next-hop-self
Parameters
IP-ADDRESS
PEER-GROUP-NAME
Default
By default, this option is disabled.
Command Mode
Router Configuration Mode.
terminated when the threshold is exceeded.
Specifies the IP address of the BGP-speaking neighbor.
Specifies the name of a BGP peer group.
183

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxs-3600-32s

Table of Contents