D-Link DXS-3600 Series Reference Manual page 935

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ip pim register-checksum-wholepkt rp-address-list ACCESS-LIST-NAME
no ip pim register-checksum-wholepkt
Parameters
ACCESS-LIST-NAME
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If this setting is disabled, the checksum for the registered packets is calculated only over the header. This
command can be only specified once. The later applied command will override the previous setting.
Example
This example shows how to enable the register checksum over the whole packet when sending to RP of
10.1.1.1.
Switch# configure terminal
Switch(config)# ip access-list rp_filter
Switch(config-ip-acl)# permit host 10.1.1.1
Switch(config-ip-acl)# exit
Switch(config)# ip pim register-checksum-wholepkt rp-address-list rp_filter
Switch(config)#
79-8 ip pim register-probe
This command is used to configure the register probe time. Use the no form of the command to revert to
the default setting.
ip pim register-probe SECONDS
no ip pim register-probe
Parameters
SECONDS
Default
By default, this value is 5 seconds.
Command Mode
Global Configuration Mode.
Specifies the name of the IP access list which specifies a list of RP
addresses. This is the address in the source address field of the
access list entry.
Specifies the register probe time value in seconds. The range is from 1
to 127.
935